Secret to on the job success
#1: On time is late
#2: Always keep one part of your body moving but not the mouth.
#3: Learning does not occur by assmosis.
Roll Grooving with Ridgid 300, and Ridgid 916 Roll Groover.
Grooving on 2" Schedule 10 Pipe, typically used for sprinkler systems.
Cut with Milwaukee Abrasive cut off wheel.
Using Victaulic fittings. Check with Pi Tape. Compare to the Victaulic specification sheet.
Piping systems are intended to be run square with any change in direction, no matter how slight, accomplished with a bend. The code and manufacturer's specifications sometimes allow for a very slight change in direction called "deflection" usually 5 degrees or less, which occurs when a pipe joint is slightly off of square. See for example the deflection specifications for Victaulic groove and shoulder joints.
No comments:
Post a Comment